Blagdon-pump X50 High Pressure User Manual

HG-CF-1087 Rev. I – 01.05.13 PAGE 1 B50 & X50 Full Flow High Pressure Series This pump is Atex approved for use in potentially explosive atmos

HG-CF-1087 Rev. I – 01.05.13 PAGE 10 WETSIDE ASSEMBLY PARTS REF No. PART No. DESCRIPTION QTY 1 A041 BOLT M8 x 30 16 2 C013 WASHER M8 16 3

HG-CF-1087 Rev. I – 01.05.13 PAGE 11 WETSIDE EXPLODED ASSEMBLY AIRSIDE EXPLODED ASSEMBLY

HG-CF-1087 Rev. I – 01.05.13 PAGE 12 ELASTOMER TABLE REF No. DESCRIPTION BUNA-N NEOPRENE EPDM VITON PTFE QTY 4 VALVE BALL 1B010 1B056 1B052

HG-CF-1087 Rev. I – 01.05.13 PAGE 13 TECHNICAL NOTES :- Removal of Diaphragm Shaft :- After first removing manifolds and air-hoses, remove both oute

HG-CF-1087 Rev. I – 01.05.13 PAGE 14 Des Monaghan, Production & Technical Manager HG-CF-223 (REV 6) IDEX Pump Technologies (Ireland) Ltd., A Unit

HG-CF-1087 Rev. I – 01.05.13 PAGE 2 Date Details Completed Service / Maintenance Log Contact Phone / Fax No. Contact Information RECYCLING

HG-CF-1087 Rev. I – 01.05.13 PAGE 3 B50 & X50 Full Flow 2:1 Pump Performance Curve, based on water at ambient temperature B50 / X50 General Assem

HG-CF-1087 Rev. I – 01.05.13 PAGE 4 TECHNICAL DATA FLUID CONNECTIONS CAPACITY MAX SOLIDS MAX DISCHARGE HEAD DISPLACEMENT/STROKE 2” BSP (F) 0 - 3

HG-CF-1087 Rev. I – 01.05.13 PAGE 5 PRINCIPLE OF PUMP OPERATION This ball valve type diaphragm pump is powered by compressed air and is a 2:1 ratio

HG-CF-1087 Rev. I – 01.05.13 PAGE 6 Before pump operation, inspect all gasketed fasteners for looseness caused by gasket creep. Re-torque loose faste

HG-CF-1087 Rev. I – 01.05.13 PAGE 7 TROUBLE SHOOTING GUIDE NOTE :- Check all solutions before dismantling the pump. PROBLEM CAUSE SOLUTION Pump wil

HG-CF-1087 Rev. I – 01.05.13 PAGE 8 Read these instructions completely, before installation and start-up. It is the responsibility of the purchaser t

HG-CF-1087 Rev. I – 01.05.13 PAGE 9 EXHAUST SAFETY WHEN PUMPING HAZARDOUS LIQUIDS Suction Lift Installation Flooded Suction Installation Submerged In